esp32: Fix USB deinit/reinit path via soft reset.

Fixes problems with USB-CDC state after soft reset if USBDevice has been
active with the default USB-CDC driver also enabled.

This also brings ESP32 behaviour in line with RP2 and other ports, where
boot.py is executed before the runtime USB device is initialised. This
allows setting up a custom USB device in boot.py.

There is still a bug here, because calling tud_disconnect() doesn't cause
any UNPLUG or BUS_RESET events to arrive from TinyUSB - which means the USB
device state stays out of sync until we call mp_usbd_init() again...

This work was funded through GitHub Sponsors.

Signed-off-by: Angus Gratton <angus@redyak.com.au>
Signed-off-by: Angus Gratton <angus@redyak.com.au>

ports/esp32/main.c

@@ -107,7 +107,7 @@ void mp_task(void *pvParameter) {
     #if MICROPY_HW_ESP_USB_SERIAL_JTAG
     usb_serial_jtag_init();
     #elif MICROPY_HW_ENABLE_USBDEV
-    usb_init();
+    usb_phy_init();
     #endif
     #if MICROPY_HW_ENABLE_UART_REPL
     uart_stdout_init();
@@ -145,6 +145,11 @@ soft_reset:
     // run boot-up scripts
     pyexec_frozen_module("_boot.py", false);
     int ret = pyexec_file_if_exists("boot.py");
+
+    #if MICROPY_HW_ENABLE_USBDEV
+    mp_usbd_init();
+    #endif
+
     if (ret & PYEXEC_FORCED_EXIT) {
         goto soft_reset_exit;
     }
@@ -193,7 +198,7 @@ soft_reset_exit:
     mp_thread_deinit();
     #endif
 
-    #if MICROPY_HW_ENABLE_USB_RUNTIME_DEVICE
+    #if MICROPY_HW_ENABLE_USBDEV
     mp_usbd_deinit();
     #endif
 
@@ -219,6 +224,7 @@ soft_reset_exit:
 
     mp_deinit();
     fflush(stdout);
+
     goto soft_reset;
 }
 

ports/esp32/usb.c

@@ -38,7 +38,7 @@
 
 static usb_phy_handle_t phy_hdl;
 
-void usb_init(void) {
+void usb_phy_init(void) {
     // ref: https://github.com/espressif/esp-usb/blob/4b6a798d0bed444fff48147c8dcdbbd038e92892/device/esp_tinyusb/tinyusb.c
 
     // Configure USB PHY
@@ -51,10 +51,6 @@ void usb_init(void) {
 
     // Init ESP USB Phy
     usb_new_phy(&phy_conf, &phy_hdl);
-
-    // Init MicroPython / TinyUSB
-    mp_usbd_init();
-
 }
 
 #if CONFIG_IDF_TARGET_ESP32S3

ports/esp32/usb.h

@@ -28,7 +28,7 @@
 
 #define MICROPY_HW_USB_CDC_TX_TIMEOUT_MS (500)
 
-void usb_init(void);
+void usb_phy_init(void);
 void usb_usj_mode(void);
 
 #endif // MICROPY_INCLUDED_ESP32_USB_H