diff --git a/Board-STM32F745-Discovery.md b/Board-STM32F745-Discovery.md
index 2e961a8..ebe4c0f 100644
--- a/Board-STM32F745-Discovery.md
+++ b/Board-STM32F745-Discovery.md
@@ -30,5 +30,6 @@ DFU mode is available on the USB FS connector (CN13)
 * I chose to install a switch between the MCU side of R42 and 3.3v (see picture below).
 * You can install the initial micropython image using the STLINK interface, and then use pyb.bootloader() to enter DFU mode from the REPL.
 
-[STM32F7 Discovery Board](https://www.dropbox.com/s/bbypmt8tennczh7/STM32F7-Discovery.jpg?dl=0)
-
+Here is a link to a photo of [my modified STM32F7 Disocvery Board](https://www.dropbox.com/s/bbypmt8tennczh7/STM32F7-Discovery.jpg?dl=0)
+The white wire connects to R42. CN13 has a USB cable plugged into it. The FTDI board is plugged into D0 (RX) and D1 (TX).
+The red wire connects to 3.3v on R39.