Assuming proper C99 language support, we can select "the int type as big as
a pointer" (most of the time) or "the 64-bit int type" (nanboxing with
REPR_D), and then define everything else automatically.
This simplifies port configuration files. And the types can still be
overridden if needed.
Signed-off-by: Jeff Epler <jepler@unpythonic.net>
This commit unifies the configuration of MICROPY_PY_CRYPTOLIB,
MICROPY_PY_HASHLIB_MD5 and MICROPY_PY_HASHLIB_SHA1, so they are enabled by
default if MICROPY_PY_SSL is enabled. This matches the existing
configuration of most of the ports.
With this change, all ports remain the same except:
- reneses-ra now enables MICROPY_PY_CRYPTOLIB, MICROPY_PY_HASHLIB_MD5 and
MICROPY_PY_HASHLIB_SHA1.
- rp2 now enables MICROPY_PY_HASHLIB_MD5.
Signed-off-by: Damien George <damien@micropython.org>
They are enabled when SSL/mbedTLS is included in the firmware. These new
features cost around +1400 bytes of code size.
Signed-off-by: Damien George <damien@micropython.org>
Most extmod network drivers were being defined on a per-port basis,
duplicating code and making enabling a driver on a new port harder.
This consolidates extmod driver declarations and removes the existing
per-port definitions of them.
This commit has been verified to be a no-op in terms of firmware change.
Signed-off-by: Andrew Leech <andrew.leech@planetinnovation.com.au>
The same MicroPython firmware is built for the HE but with slightly
different options, for example no USB.
Signed-off-by: iabdalkader <i.abdalkader@gmail.com>
This commit adds the beginning of a new alif port with support for Alif
Ensemble MCUs. See https://alifsemi.com/
Supported features of this port added by this commit:
- UART REPL.
- TinyUSB support, for REPL and MSC.
- Octal SPI flash support, for filesystem.
- machine.Pin support.
General notes about the port:
- It uses make, similar to other bare-metal ports here.
- The toolchain is the standard arm-none-eabi- toolchain.
- Flashing a board can be done using either the built-in serial bootloader,
or JLink (both supported here).
- There are two required submodules (one for drivers/SDK, one for security
tools), both of which are open source and on GitHub.
- No special hardware or software is needed for development, just a board
connected over USB.
OpenMV have generously sponsored the development of this port.
Signed-off-by: Damien George <damien@micropython.org>
Signed-off-by: iabdalkader <i.abdalkader@gmail.com>
